![]() Using a screwdriver, we remove the tank, removing its nozzles from the connecting tubes We pump out the brake fluid from the tank with a rubber bag or a syringe Removing the brake master cylinder tankĭisconnect the wire from the negative terminal of the batteryĭisconnect the wiring block from the brake fluid level sensor If this does not happen, then the vacuum amplifier or the check valve of the vacuum amplifier does not work, and the vacuum amplifier hose may also not be sealed. Holding the brake pedal in the pressed position, start the engine. When the engine is not running, we press the brake pedal five or six times on the brake pedal. If the force on the brake pedal has noticeably increased during braking, you need to check the amplifier on a stationary car. If the vacuum booster is faulty, the force on the brake pedal increases significantly. The vacuum brake booster is replaced when it fails. the compensation holes are clogged (spontaneous braking of the car occurs) wear or damage to the piston cuff of the main cylinder contamination of the main cylinder or a large wear of its mirror The main cylinder of the brakes and the vacuum brake booster are replaced in case of defects.ĭefects of the main brake cylinder, which should be repaired or replaced:
0 Comments
Leave a Reply. |